The present document has been developed within the 3rd Generation Partnership Project (3GPP TM) and may be further elaborated for the purposes of 3GPP. The present document has been developed within the 3rd Generation Partnership Project (3GPP TM) and may be further elaborated for the. 3GPP. (j). Service accessibility. Retrieved 21 September from Home page of 3GPP technical specification groups (TSGs). /htmlinfo/htm.
|Published (Last):||17 December 2011|
|PDF File Size:||20.21 Mb|
|ePub File Size:||11.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
When DCI format 1C is used the maximum allowed by the physical layer is bits bytes while for format 1A the limit is bits bytessee TS A structural element containing a single or multiple fields is referred as information element. The PCell is used to provide the security inputs and upper layer 3gpo information i.
Following T expiry any dedicated preamble, if provided within the rach-ConfigDedicated, is not available for use by the UE anymore. That is, the 36313 to the message used to activate security is not ciphered, while the subsequent messages e.
The cell in which the re-establishment procedure succeeds becomes the PCell while SCells, if configured, are released. The measured quantities are filtered by the 3bpp filter as configured in the mobility measurement configuration.
In addition sub-clause 5. Normal measurement and mobility procedures are used to support handover to cells broadcasting a CSG identity.
Mathematical function used to ’round down’ i. The modification period is configured by system information. In the next modification period, the network transmits the updated system information.
An RN configured with an RN subframe configuration does not 366331 to apply the system information acquisition and change monitoring procedures. The UE applies the system information acquisition and change monitoring procedures for the PCell only. The target eNB decides which SCells are configured for use after handover, which may include cells other than the ones indicated by the source eNB.
Whenever the UE shall setup or reconfigure a configuration in accordance with a field that is received it applies the new configuration, except for the cases addressed by the above statements. NAS dedicated information transfer, UE capability transfer, sub-clause 5.
The UE may discard SRB2 messages and data that it receives prior to completing the reconfiguration used to resume these bearers. The additional information is used to verify whether or not the UE is authorised to access the target PCell and may also be needed to identify handover candidate cell PCI 3gop i.
For further details see TS Lower layers discard RRC messages for which the integrity check has failed and indicate the integrity verification check failure to RRC.
www.3gpp.org – /ftp/specs/archive/36_series/36.331/
The UE applies the previously acquired system information until the UE acquires the new system information. Radio configuration is not just the resource configuration but includes other configurations like MeasConfig and OtherConfig.
The details of the CDMA state models are out of the scope of this specification. Upon successful completion of the handover, the UE sends a message used to confirm the handover. The number of warning messages that a UE can re-assemble simultaneously is a function of UE implementation. Only in exceptional cases, as specified within this specification, TS If the UE receives a Paging message including the systemInfoModification, it knows that the system information will change at the next modification period boundary.
A term defined in the present document takes precedence over the definition of the same term, if any, in TR The physical layer imposes a limit to the maximum size a SIB can take. Security mode command, failure The purpose of this procedure is to activate AS security upon RRC connection establishment. Correspondingly, the UE initially considers lists to be empty e. The source eNB transparently i. However, the UE needs to perform system information acquisition upon cell re-selection.
Unless explicitly stated otherwise in the procedural specification, the system information acquisition procedure overwrites any stored system information, i.