ASTM A682 PDF

ASTM A Standard Specification for Steel Strip, High Carbon, Cold Rolled, General Requirements. Find the most up-to-date version of ASTM A at Engineering ASTM A, AM – Designation: A /A M – 02 An American National Standard Standard Spe.

Author: Mimuro Malkis
Country: Cape Verde
Language: English (Spanish)
Genre: Technology
Published (Last): 17 February 2014
Pages: 116
PDF File Size: 10.25 Mb
ePub File Size: 15.82 Mb
ISBN: 942-1-15497-231-4
Downloads: 40396
Price: Free* [*Free Regsitration Required]
Uploader: Tojalkis

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM A Steel, Strip, High Carbon, Cold Rolled, General Requirements

Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. However, under SI the preferred term in mass. Combining values from the a862 systems will result in nonconformance with the specification.

For strip length under mm, camber tolerance shall be subject to negotiation. B The sum of copper, nickel, chromium, and molybdenum shall not exceed 0.

Materials and Manufacture 5.

Combining values from the two systems will result in nonconformance with the specification. B Measured 10 mm or more in from edge; and on narrower than 25 mm, at any place between edges. Dimensions, Mass, and Permissible Variations 9.

  ALFONSO USSIA LIBROS PDF

Normal coiling or piling does not provide a 3 Where an ellipsis. It is normally produced as a fully killed steel.

Unless otherwise agreed to, all tests and inspections, except product analysis, shall be made at the place of production. Each of the elements listed in Tables 2 and 3 and additional elements agreed upon by the purchaser and the supplier shall be included in the report of heat analysis.

When agreed by purchaser and supplier, other silicon ranges are permissible. Within the text, the SI units are shown in brackets. Government procurement by the Defense Supply Agency, strip material shall be continuously marked for identi? NOTE 2—The industry de?

When one or more of these elements is speci? The values listed are not exact conversions of the values listed in the inch-pound tables but instead are rounded or rationalized values. Combining values from the two systems will result in nonconformance with the speci?

ASTM A, AM_百度文库

Conformance to SI tolerances is mandatory when the “M” specification is used. NOTE 1—The term weight is used when inch-pound units are the standard.

C When edge, width and thickness are not de? If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Ast, on Standards, at the address shown below.

  CEREBROTENDINOUS XANTHOMATOSIS PDF

ASTM A682 Grade 1074

Stay on Page Continue to Compass. Finish and Edges zstm However, unless the order specifies the applicable “M” specification designation SI unitsthe material shall be furnished to inch-pound units. ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.

Strip tolerance products may be available in widths wider than ? Astj previous edition A — This standard has been approved for use by agencies of the Department of Defense. Rejection and Rehearing Over 12 Through 11? Strip is classified as product that is 0. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.

However, unless the order speci?