BQT E5-500W PDF

1 fan ( mm). Connectors be quiet! Straight Power BQT EW. Type of connector for the motherboard: 20+4 pin. Number of connectors 4-pin CPU: 2. The be quiet! Straight Power BQT E The be quiet! BQ T E W. W. 6W. 12,5 W. 30A. 30A. 0,5A. W. – Va c. 50 – 60Hz. 10 – 5A. W. Be quiet! no unknown quantity is surely manufacturer, if it concerns power packs. In Silencerkreisen by the earlier P5 and P6 and the.

Author: Akigami Voodookree
Country: El Salvador
Language: English (Spanish)
Genre: Love
Published (Last): 1 March 2005
Pages: 108
PDF File Size: 12.8 Mb
ePub File Size: 2.37 Mb
ISBN: 772-6-30892-384-1
Downloads: 62880
Price: Free* [*Free Regsitration Required]
Uploader: Moogull

Ebay sure can find fake caps from 5e-500w with appropriate size, but that’s another thing. It prevents startup and can fry 5VSB related components due to them running hot. You installed the jumper wires backwards Main PC: Dark Power Pro 11 W.

Find More Posts by wacce. Straight Power E7 W.

I’ve had a really bad EW once which seems nqt have been used with bad caps up to the point where the diodes in the 5VSB area around the smaller transformer were running hot for so long that the PCB disintegrated and disconnected them bottom of the PCB was black in that area and literally turned into dust upon touching it. Straight Power E8 W. Ah, the plague of CapXons continues. Or they could be for the standby, but causing problems when the computer tries to start – as it will draw a bit more from standby on start up.

If it doesn’t work, then you can recap it again and squeeze in some more appropriate replacements. System Power 8 W.

This is my first time posting though, as I’ve run into a problem. Power supplies are now coming into their own in the PC-build market with an increasingly large number bqqt builders, including first-timers, recognizing the need for high-end, stable PSUs to drive their custom rigs.

  ISO 4301-5 PDF

I’m not good at reading the board layout, so I can’t tell if the lower capacitance would have some effect on the behavior of the circuit.

Be Quiet Pure Power 11 W. The PSU in the attached pics isn’t that bad in terms of amount of white gunk. Power Zone W.

Review Be Quiet! Straight Power BQT EW W – Powersupply

Was this review helpful? Category Displays only products from the chosen category. This PSU is going for a bqy, so I’ll have to make sure it stays alive as long as possible I do happen to have a black Yate Loon mm fan, which might be an appropriate replacement for the current fan, or I could take an orange one from Nexus W PSU.

What’s also interesting in the second cap is, that it was covered with a rubber “sock”, best seen in the last picture.

Find More Posts by momaka. TFX Power 2 W. These would be much easier to get. Be Quiet Straight Power 10 W.

TechPowerUp Review Database

Personally, I just put a resistor in parallel with the thermistor, so that the controller wakes up sooner. Post on the forums instead! Dark Power Pro P10 W. There will be no compensation issues with a low power output like that.

Straight Power 10 W. Dark Power Pro Be Quiet Straight Power 11 W.

Last edited by wacce; at Dark Power Pro P9 W. FWIW, It’s about 2. When plugged into a motherboard the motherboard led turns on, but when trying to power the board on, fans will turn a little e5-5500w then nothing. Be Quiet Power Zone W. Be Quiet BQT EW recap, odd sized CapXon The only way to add a resistor or a pot temporarily to the thermistor is by soldering it in on the bottom of the PCB, as the thermistor is underneath the secondary side heatsink and some E5’s have so much white gunk in that area that you can’t even see the little TO92 transistor right next to it let alone see the thermistor pins because it’s covered in that stuff.

  BDL4631V 00 PDF

While the Straight Power W is per cent stable, efficient and has braided cables, its fairly expensive e5-50w a W PSU, retailing for the same price as the Antec Neo HEwhich has modular cables.

Any experiences on those? Dark Power Pro W.

be quiet! Straight Power BQT E5-500W – Power Supplies specifications.

Thessaloniki, Greece My Country: Average score from owners of the product. Pure Power 10 W. Straight Power 11 W and W. The only way to add a resistor or a pot temporarily to the e5-500w is by soldering it in on the bottom of the PCB, as the thermistor is underneath the secondary side heatsink and some E5-5500w have so much white gunk in that area that you can’t even see the little TO92 transistor right next to it let alone see the thermistor pins because it’s covered in that stuff.

Find More Posts by tom BeQuiet Straight Power Their plight, in fact is even worse, they don’t realize that they’re cantonists, they think they’re free men.

I used flash on my camera to see the surroundings better. Product age Excludes all products which are older than the age you have chosen. The problem here is the size of those failed caps.