Comme pour les coussinets et les bandes composites, SKF fabrique de série des rondelles de butée composites à partir de matériaux composites PTFE et POM. For additional information about the meaning and limitations of the product data, refer to SH bushings. Imprimer cette page; Partager. d, 35, mm. D, 60, mm. D1, 68, mm. L, 37, mm. L1, 49, mm. B, , mm. Calculation data. Max. torque, Mv, , N·m. Max. axial load, Pa, 41, kN. Mounting.

Author: Mazusida Kelkis
Country: Great Britain
Language: English (Spanish)
Genre: Literature
Published (Last): 6 October 2015
Pages: 174
PDF File Size: 11.1 Mb
ePub File Size: 15.65 Mb
ISBN: 317-2-31755-583-5
Downloads: 41007
Price: Free* [*Free Regsitration Required]
Uploader: Zulkile

Joints à frottement mécanique, coussinets SH – SHT 48

Check that the counter surface shaft seat and other components such as the housing are clean, deburred and that they do not contain any abrasive particles. For larger bushings, SKF recommends using a mounting ring fig. Otherwise when the bushing comes in xkf with absorbent material it may wick the oil away very quickly.

Care should always be taken when mounting FW bushings not to damage the sliding layer or side faces. Imprimer cette page Partager Partager cette page. In addition, cleanliness, and understanding the causes of premature bearing failure can help too.


If composite plain bearings, for example strips, are to be located in a housing using an adhesive, the adhesive should be suitable for the expected operating temperature and should have suitable expansion, aging resistance, strength and curing properties.

Modèles et variantes

When mounting, thrust washers should be positioned so that the steel backing abuts the housing wall. The position of the lubrication groove couxsinets solid bronze bushings depends on whether it is an oscillating or rotating or movement and, for the latter, whether oil or grease lubrication is applied fig.

SKF also recommends, particularly for larger bushings where more force is required that they be cooled before mounting.

To do coussiets, place an O-ring on the dolly to keep the bushing in position. SKF sintered bronze bushings are impregnated with a lubricant and. To install bushings, with or without a flange, SKF recommends using a mounting dolly particularly for composite fig.

To facilitate the mounting of small bushings, apply a light coating of oil or grease to the housing bore.


If no operational experience is available, SKF recommends contacting an adhesive manufacturer for advice.

Once all the components have been cleaned and checked, the bushing is ready to be installed. Sufficient cooling fluid should be applied as well to avoid excessive temperatures, as they can destroy the bushing. Mounting Skill and care in mounting are prerequisites for long bearing service life. Check also the shaft for sharp edges, burrs or surface defects, which could damage the sliding surface of the bushings.

To facilitate mounting FW busings, the bushing may be split lengthwise into two halves by using a diamond coated grinding wheel. Then drive the bushing into place with a mechanical or hydraulic press or by tapping the dolly lightly with a hammer. When applying an adhesive, care should be taken so that no adhesive reaches the sliding surface.