JIS G0404 PDF

Find the most up-to-date version of JIS G at Engineering JIS G Steel and steel products — General technical delivery requirements (Foreign Standard). Available for Subscriptions. Content Provider. Hi! I am finding JIS G , English version, who have this standrad. Pls, upload.

Author: Bazuru Doubar
Country: New Zealand
Language: English (Spanish)
Genre: Science
Published (Last): 24 January 2007
Pages: 95
PDF File Size: 4.22 Mb
ePub File Size: 5.38 Mb
ISBN: 451-5-66684-204-8
Downloads: 50720
Price: Free* [*Free Regsitration Required]
Uploader: Jumuro

Hardness value which is g00404 in the hardness conversion table shall be calculated by interpolation. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. For those of diameter 3 mm or less, the reduction of area is not specified.

In JIS, a part of items are deleted. For the steel coil, however, some irregular portions and welds may be included therein, since generally the steel coil is afforded no opportunity to inspect and to remove such defective parts.

JIS G 0404:2014

In JIS, tensile strain hardening exponent was deleted. You must have JavaScript enabled in your browser to utilize the functionality of this website.

Domestic and commercial equipment. LS side tolerances t be applied to the 3r-levelled steel Table 18 Width tolerances.

  BIT STUFFING IN HDLC PDF

IDT Annex 1 Hardness of the standard temper grade and as-annealed grade, ten- g00404 strength of hard materials, as well as the matters to be attended at the time of nis are described for reference.

However, the tolerances on thickness shall be in accordance with table 4 and the measurement of edge camber shall be carried out when requested by the purchaser. Full text of ” JIS G The average ratio of plastic strain r shall be as given in table 6. Terms are defined in JIS G Remarks 1 Flatness shall be measured by laying a steel sheet under its own mass on a flat surface plate, and the value of flatness shall be determined as the difference between the maximum deviation of jiz from the flat surface and the nominal thickness of the steel sheet when its convex side is upper-most.

The appearance is specified.

Wires Date of Establishment: The measurement of the camber shall be conducted only when requested by the purchaser. Energy and heat transfer engineering Deletes the specification item s or content s of International Standard.

Latest News of the Blog. Rubber and plastic industries Table 13 Standard dimensions Unit: A list of modifications with the explanations is given in annex 1 informative.

  CORELLI CONCERTO PER LA NOTTE DI NATALE PDF

Since terms are defined in JIS Git is kept as it is. Attention is drawn to the possibility that some parts of this Standard may conflict with a patent right, application for a patent after opening to the public, utility model right or application for registration of utility model after opening to the public which have technical properties. However, in the case by processes other than process D and process DA, they shall be subjected to the agreement between the purchaser and the supplier. The maximum values of camber, classified into A and B, shall be as shown in table 23 and table 24, respectively.

The tensile and bend test pieces shall be taken parallel to the rolling direction.

JIS G Carbon steels for cold heading –

A list of modifications with the explanations is given in Annex 2 informative. Aircraft and space vehicle engineering Chemical composition of Deletion four elements C, Mn, P, S and additional alloy elements are specified.

Paint and colour industries Judgement of the reinspection g004 specified. The test method shall be as specified in JIS Z