Automatic Chain Drive/Belt Drive Garage Door Operator System Ownerâs Manual SAVE FOR FUTURE REFERENCE Customer Service. Overhead Door Garage Door Opener Owner’s Manuals. describe the image. The Overhead Door Legacy (model #/) garage door opener. CD Series Garage Door Opener pdf manual download. Also for: Cdb Garage Door Opener Overhead door legacy Programming And Operating Manual . CAUTION Line “V” “B” Header bracket must be fastened to garage fram- ing.
|Published (Last):||5 May 2010|
|PDF File Size:||2.43 Mb|
|ePub File Size:||14.3 Mb|
|Price:||Free* [*Free Regsitration Required]|
There are two screws on the side of the opener to adjust the lift and close pressure. Check operation of buttons. Install door operator 7 feet or more above the floor.
Legacy CD-B Owners Manual –
That may be the reason the opener lift pressure is kicking it out. The email address entered is already associated to an account. Attach visor clip to remote control Fig.
In sight of door. Set door operator so minimum force is neededto operate door. Tighten hex head screws. Whether you are replacing an existing garage door operator or installing an operator in yourgarage for the first time, there are some pre-installation issues which need to be addressed.
Overhead door legacy cd b manual. Use wall control to run door open and close. If you plan to plug the unit into a standard electrical outlet, is one available? If garage has only one garage door. Each button on a multi-button remote controlis for a different operator.
Door will only run open.
Legacy 696CD-B Garage Door Opener Owners Manual
Lights will not go out. Slide bottom cover off. Lawrence Oravetz Level 3 Expert Answers. If your door sticks, binds, or is out of balance, have it adjusted by a professional.
Support header end of channel level with power head. This is about the size of a 2 x 4To reduce the risk of severe injury or death: Draw horizontal line H across line Legac at this point Fig Align mounting oegacy of sprocket saddle, boom and power head frame.
Point remote control at door. Lawrence Oravetz Level 3 Expert Answers. Drive staples just tight enough to hold wire. Model – Motor 5 Years and all other parts 3 years. If direct wiring is Legac required, plug door operator into grounded outlet Fig. Posted on Aug 19, Jun 27, Building Materials.
Alliance, Ohio Call: There are no obstructions. Determine which side of garage receives most direct sunlight Fig. Was a remote control lost or stolen? Check force adjustment See Section 7.
Keep door in sight until it is completely closed. Is this a sensitivity problem? Connect white manula to terminal 1 on power head and W on wall control. Do Not try to remove, repair or adjust springs or anything to which door spring parts are fastened, such as, wood blocks, steel brackets, cables or other like items.
Fasten channel to power head.
Extension cords can cause dangerousoverheating conditions. Worked perfect before this. Failure to adjust the operator properly may cause severe injury or death.
Slide drive end of channel down over D-shaft on top of power head Fig. If not, seek a repair service. Make sure you put the black cup back on the end of the motor shaft and that it is pressed all the way on.
Dec 19, Building Materials.
E-mail Back to log-in.